2
GF6580B-1-INS-LAB-RevC10
Head End Pivot Point Crossbrace Installation
1. Locate the two head deck
angle slots on either side of
the bed closest to the head
end pivot point (see near
right picture).
2. Position the head end
pivot point crossbrace so it
extends across the bed. En-
sure the stabilizers remain at the bottom of the crossbrace and rotate the rail guides so the long ends
face upward and the spring buttons face the bed's foot end, as shown in above center picture.
3. Insert one of the crossbrace stabilizers into the slot across the bed from you. Compress the spring-
loaded crossbrace until the second stabilizer aligns with the slot closest to you and lower it into the
slot. Slowly release crossbrace until it locks into place.
4. Rotate the crossbrace so the long ends of the rail guides face downward and the spring buttons face
the bed's head end, as shown in above far right picture.
Head End Crossbrace Installation
1. Locate the two head deck angle
slots on either side of the bed
closest to the bed's head end
(see near right picture).
2. Position the head end cross-
brace so it extends across the
bed. Ensure the stabilizers re-
main at the bottom of the crossbrace and rotate the rail guides so the long ends face upward and the
spring buttons face the bed's head end, as shown in above center picture.
3. Insert one of the crossbrace stabilizers into the slot across the bed from you. Compress the spring-
loaded crossbrace until the second stabilizer aligns with the slot closest to you and lower it into the
slot. Slowly release crossbrace until it locks into place.
4. Rotate the crossbrace so the long ends
of the rail guides face downward and the
spring buttons face the bed's foot end,
as shown in above far right picture.
Head Rail Installation
1. Align the two legs of each rail over the
crossbrace rail guides. Ensure the outer
telescoping rail tubes are facing the
bed's head end and the rail rivet stops
are facing outward, as shown at right.
2. Gently pull out the spring buttons and
lower the rail until both buttons click
into position in the first holes on both
rail legs, locking down the rail.
WARNING: Ensure the outer telescoping
rail tubes face the head end of the bed as
shown at right; if positioned otherwise, a
pinch point could occur when bed is raised
or lowered.
INSTALLATION AS FOOT RAILS
Remove bedding and mattress. Ensure that the bed deck is in the flat position.
pivot
point
pivot point
slot
slotted
head deck
angle
foot end
locate
head end
pivot point slots
head end
detail
area
detail: install
pivot point
crossbrace
head end
spring
button
long end
anti-slide tab
rail guide
stabilizer
pivot point slot
rail
guide
spring button
pivot point
crossbrace
detail: pivot point
crossbrace
installed
head end
head end slot
slotted
head deck
angle
foot end
locate
head end
slots
head end
detail area
detail: install
head end
crossbrace
head end
stabilizer
rail
guide
head end slot
anti-slide tab
spring button
long
end
detail: head
end crossbrace
installed
head end
spring
button
rail guide
head end
crossbrace
foot end
head end
right
side
left
side
pivot point crossbrace
head end crossbrace
right rail outer telescoping tube
rail rivet stops face outward
head end rail guide
pivot point rail guide
left rail outer
telescoping tube
spring buttons
face each other
quarter rails
installed as head rails
