GM · CONVERTING UNIT
66
28.
Starting up the machine:
Test and training can not be carried out unless the following materials are available on site:
- Label material, min. 2000m with a web width of 330mm.
(It is not possible to run a web with a width less than 330mm as the standard print roller is
320mm)
-
A printed test job must be prepared and ready, min. 1000m web.
-
UV-varnish min. 10 (XSYS Print Solutions / Akzo Nobel UVD 00100-405)
-
UV-Wash min 5L (CLU00102-407 or UV Wash2 or Dowanol DPM)
-
A die plate and a job for the plate must be prepared and ready to run on the Xeikon DCP
(Drop = 0,48mm see manual for the machine for distortion information )
-
Super gloss foil min. 500m is available (width 330mm).
(Pütz Folien GMBH XUC B11 330mm)
-
A cliché and a job for spot varnish must be prepared if the machine has spot varnish
( Cliché 1,14mm or 1,7mm double-sided tape 0,38 mm or 0,55mm, Distortion typical. 9,93 for
12” cylinder)
Anilox 10cm3, Glue from X-Sys Cold foil UV-FOILBOND UVH00002, Kurz foil.
