20
REQUIREMENTS ON THE INSTALLATION LOCATION
For safe and fault free operation of the unit, the following requirements of the installation location
have to be met:
●
The unit has to be placed on a solid, flat, horizontal, and non-slipping surface with a sufficient
weight-carrying capacity.
●
Make sure that the unit cannot topple over.
●
Choose the location in such a way that children cannot reach the supply line of the unit.
●
Do not place the appliance on hot surfaces, such as hotplates, or near them.
●
Never use the unit in the open, and store in a dry location.
●
The unit is not designed for installation in a wall or a built-in cupboard.
●
Do not set up the unit in a hot, wet or moist environment.
●
The socket has to be easily accessible so that the power cable can be removed easily in
case of emergency.
●
The unit has a strong upward heat emission. Never put the unit under a cabinet, under cur-
tains or next to inflammable materials.
●
Never put the unit in the proximity of paper, fabric or similar materials. The bread can burn.
ELECTRICAL CONNECTION
For safe and fault-free operation of the unit, the following requirements have to be met during
the electrical connection:
●
Before connecting the unit, compare the connecting data (voltage and frequency) on the
type plate with those of your energy network. These details must correspond so that no dam-
age occurs to the unit. In case of uncertainty, contact a qualified electrician.
●
The socket has to be protected at least by a 10 amps circuit breaker.
●
Make sure that the power cable is not damaged and is not laid across hot surfaces or sharp
edges.
●
The connecting cable must not be stretched tightly.
●
The electric safety of the unit is ensured only when it is connected to a socket with protective
conductor installed correctly. Operation on a socket without protective conductor is forbid-
den. If in doubt, let the house installation check by a trained electrician. The manufacturer
shall not assume responsibility for damage which has been caused by absent or interrupted
protective conductor.
PRIOR TO FIRST USE
During initial operation, operate the unit once to twice without roasting product at the highest
level, because slight odour development can occur due to potential residual dust on the heating
elements.
TOASTING
Connect the unit to the power grid:
●
Put the roasting product into the slits
