2 2 5 T
O U R N A M E N T
8–2
O p e r a t i o n O f S t a n d a r d F e a t u r e s
S
WITCH
P
ANEL
At the helm you will find an accessory switch panel. Not all boats are equipped with the same
accessories. Consult your dealer for specific information or questions on the accessories included
on your boat.
• Bilge Pump
This two-way switch serves as an overriding manual switch in the event of failure of the
automatic switch in the bilge. A circuit breaker located above this switch provides over-
current protection for this circuit.
• Cockpit Lights
The cockpit lights provide illumination in the cockpit area. A circuit breaker located above
this switch provides over-current protection for this circuit.
• Horn
The horn meets the requirements of the USCG for sounding devices. A circuit breaker located
above this switch provides over-current protection for this circuit.
• Livewell
This switch activates the optional livewell system. A circuit breaker located above this switch
provides over-current protection for this circuit.
• Navigational/Anchor Lights
This three-position switch (NAV-OFF-ANC) changes the lighting configurations to running or
anchor lights. A circuit breaker located above this switch provides over-current protection for
this circuit.
• Trim/Tilt
The trim/tilt switch is located on the throttle control. Trim changes the angle of thrust of the
engine (reference
“Trim” on page 4–1
). Tilt raises the drive unit for trailering.
• Trim Tab
These switches control the hydraulic trim tabs used for adjusting the attitude of the boat. See
“Trim Tabs” on page 8–5
for more details.
• Washdown
This switch activates the optional washdown system. A circuit breaker located above this
switch provides over-current protection for this circuit.
• Water Pressure
This switch activates the pressurized fresh water system. A circuit breaker located above this
switch provides over-current protection for this circuit.
• Windshield Wiper
This switch powers the windshield wiper. A circuit breaker located above this switch provides
over-current protection for this circuit.
• Accessory
Switches and breakers labeled “ACC” are blank. They may be used for non-factory installed
accessories. A circuit breaker located above this switch provides over-current protection for
this circuit. See
“Accessory Wiring Color – Fuse/Breaker Sizes” on page 6–10
for
Summary of Contents for Tournament 225
