![Grady-White Boats Express 370 Owner'S Manual Download Page 57](http://html.mh-extra.com/html/grady-white-boats/express-370/express-370_owners-manual_2253678057.webp)
E
X P R E S S
3 7 0
8–3
• Spreader Lights
This switch, located on the cockpit switch panel, activates the hardtop spreader lights. A
circuit breaker located beside this switch provides over-current protection for this circuit.
• Underwater Lights (optional)
This switch activates the underwater lights. A circuit breaker located above this switch
provides over-current protection for this circuit.
• Washer
This momentary switch operates the windshield washer. Depress and hold the top of the
switch until a sufficient amount of water is sprayed onto the windshield. A circuit breaker
located above this switch provides over-current protection for this circuit.
• Windlass
This switch operates the anchor windlass. Depress the top of the switch to raise the windlass
and the bottom of the switch to lower the windlass.
• Windshield Vent
This momentary switch activates the actuator which opens and closes the center vent in the
windshield. A circuit breaker located above this switch provides over-current protection for
this circuit.
• Wiper
This switch powers the windshield wipers. A circuit breaker located above this switch
provides over-current protection for this circuit.
• Accessory
Switches and breakers labeled “ACC” are blank. They may be used for non-factory installed
accessories. A circuit breaker located above this switch provides over-current protection for
this circuit. See
“370 DC Accessory Wiring Color - Fuse/Breaker” on page 6–10
for
recommended breaker amperages. Switch labels are available from your dealer for non-
factory installed options.
Other Switches
• Trim/Tilt
The trim/tilt switch is located on the throttle control. Trim changes the angle of thrust of the
engine (reference
). Tilt raises the drive unit for trailering.
• Trim Tab
These switches control the hydraulic trim tabs used for adjusting the attitude of the boat. See
for more details.
N O T I C E
Use anti-corrosion spray on the back of panels and on exposed wires to prevent the rust or
corrosion that could lead to an electrical system failure.
N O T I C E
Use anti-corrosion spray on the back of panels and on exposed wires to prevent the rust of
corrosion that could lead to an electrical system failure.
Summary of Contents for Express 370
