10
11
12
9
303-9-99 303999
Installing the Playtray
(on certain models)
Step 2.
Line up front of
playtray with
front edge of
activity center
tray as shown.
Step 3.
Push playtray down so both
side tabs snap under the
activity center tray.
Bar, two beads,
one ring
Teether and
stalk (style
may vary)
Phone
and cord
Steering wheel
and cap
Do not install the playtray while
your baby is in the activity center.
CHECK that you have all the parts
listed at right before assembling your
playtray.
Push and twist the ring and
two beads onto the toy bar.
Snap the toy bar into the holes
in the playtray;
slight curve in
toy bar must curve away from
steering wheel
. Be sure both
ends of the toy bar are firmly
snapped into the playtray.
Once the toy bar is inserted into
the playtray, you will not be able
to remove it.
Push end of phone cord
through small hole in tray,
then tie a knot under the tray.
Pull on phone cord to make
sure cord is secure.
Push wheel cap
onto steering wheel,
then push assembly
into large hole in
tray. Check that all
four tabs go into
hole in tray.
Insert teether stalk into
the small square hole in
the tray.
Step 1.
Assemble the toys on the tray as shown.
Step 4.
CHECK that playtray is secure
on activity center by pulling up
on playtray.
Do not lift this
product by the playtray.
Removing the Playtray
To remove tray, pull the two
side tabs outward, and lift up
playtray.
Snap music keys in
place over the printed
circuit board.
Stickers
Place three stickers on front of
tray as shown.
Rub over
stickers with hand or clean
cloth to assure adhesion.
Music key (3)
Shorter teeth
on bottom
Step 1.
To mount beads on bar: flatten
ring at one end of bar as
shown and push through
hole in center of each bead.
Step 2.
Place ring on top of
a mounting post.
Shorter teeth must
be on the bottom, as
shown. Top of mounting
post will be even with top
of ring. Snap cap into place
inside mounting post and turn
it up to one half turn until it
locks in place. Repeat with
the other ring, post and cap.
Step 3.
Mount posts onto front
corners of activity center
tray as shown until they snap
securely into place. Center of
bar should curve away from
the seat, not toward it.
Step 4.
Insert the two prongs on a toy
base into a cap at the notches.
Step 5.
Turn toy base one quarter turn
until you feel the toy snap into
place. Check that toy is firmly
inserted by pulling on the toy.
Toy is removable (turn it the
other way with a little pressure)
so that you can replace it with
other toys when desired (sold
separatelysee the enclosed
leaflet).
Bar and beads
Mounting
post
and cap
(2 each)
Mix N Move toys
(styles may vary)
To Assemble the Mix N Move
Toy Gym (on certain models)
Before assembling, check that you have all the parts
listed below:
