Clean-Up for ThermoLazer 200/200TC/300TC
34
3A1319K
Clean-Up for ThermoLazer 200/200
TC
/300
TC
1. Secure ThermoLazer by chocking wheels.
2. Use scraper to clean out trough and screed box.
Transporting
Remove LP-Gas supply cylinder from ThermoLazer
before transporting. Secure in an approved location and
method as authorized by local, state, federal, national,
and international agencies.
Always use the designated mounted lifting lugs when
lifting the Thermolazer. When lifting the Thermolazer
only use ANSI approved slings and equipment rated for
a minimum of 2000 lb. Always use ANSI approved
equipment for securing ThermoLazer to transporting
equipment.
BURN HAZARD
Never scoop out remaining melted thermoplastic from
kettle. Remaining thermoplastic can be left to harden
inside the kettle and can be remelted at a later date.
ti14603a
ti14529a
NOTICE
Be sure to thoroughly clean all material out of screed
box and any open areas to prevent material from freez-
ing moving parts of screed box. Always run all material
out of each screed box before removing. Scrape out all
remaining material before it sets within the screed box.
NOTICE
To prevent material from hardening and blocking flow,
scrape all excess material off of external surfaces after
each use, including the material trough.
NOTICE
Remove any remaining beads in the bead hopper and
bead dispenser to prevent beads from clogging hopper
and dispenser.
Summary of Contents for ThermoLazer
Page 39: ...Notes 3A1319K 39 Notes ...
