Operation
14
309832D
Operation
Pressure relief procedure
Flushing
WARNING
Follow
when you stop
spraying and before cleaning, checking, servicing, or
transporting equipment. Read
Warnings
, page 3.
1.
Shut off pump motor.
2.
Actuate applicator, dispensing material into an
empty pail, until material stops dispensing through
the applicator.
WARNING
This equipment is designed for use with standard
adhesive and sealant such as EVAs, butyls, and
polyolefins with flash points above 450°F
(232°C). Not recommended for water curable or
solvent based adhesive. Do not use flammable
material or material not compatible with the spec-
ifications of this equipment. Failure to follow this
instruction can cause injury to operators and
damage to equipment.
•
Flush before changing materials.
•
Flush at the lowest pressure possible. Check
connectors for leaks and tighten as necessary.
•
Flush with purging compound 118090.
1.
Make sure material in tank is completely dispensed.
2.
Follow
Pressure Relief Procedure
, page 14.
3.
Remove nozzle and clean with compound.
4.
From inside tank, pull out tank filter screen 118211.
Clean with purging compound and inspect for dam-
age and replace. See
Parts
, page 40.
5.
Put compound into tank.
6.
Start up the hot melt system. Follow instructions for
Starting the hot melt system
, page 15;
Adjusting
panel controls,
page 15; and
Dispensing mate-
rial
, page 18.
7.
Trigger the gun until clean compound dispenses.
8.
Turn on/off switch (R) OFF and unplug unit. See
F
9.
Remove gun from hose. See gun manual to further
clean gun.