Graco ProMix PD3K Plus, Operation

Page: 71 / 122

Setup Mode Screens
System System
System Screen
Screen
Screen 3
3
3
System screen 3 sets the following system operating
parameters.
Figure 42 System Screen 3
Stall Stall Stall Test Test Test Pressure Pressure Pressure
Set the minimum stall test pressure. The setting
should be approximately 50 psi (0.35 MPa, 3.5 bar)
higher than the highest inlet pressure.
NOTE: If the material supply pressure at the pump
inlet is greater than 90% of the Stall Test Pressure, the
system will generate an alarm and will not complete
the stall test. See
Calibrate Screen 1, page 87 .
Pump Pump Pump Stall Stall Stall Test Test Test
Set the duration for the pump stall test. See
Calibrate Screen 1, page 87 .
Maximum Maximum Maximum Leak Leak Leak Rate Rate Rate
Enter the maximum allowable leak rate for a pump
stall test.
3A6287E 71