Setup
Setup
Setup Mode
Mode
Mode Screens
Screens
Screens
Press
on any Run screen to enter the Setup
screens.
NOTE:
NOTE:
NOTE: Selection fields and buttons that are
grayed-out on the screens are not currently active.
If the system has a password lock, the Password
screen displays. See
Password
Password
Password Screen
Screen
Screen
Figure 37 Password Screen
Enter the 4 digit password, then press
. System
screen 1 will open, allowing access to the other
Setup screens.
Entering an incorrect password clears the field.
Reenter the correct password.
To assign a password, see
System
System
System Screen
Screen
Screen 1
1
1
System screen 1 includes the following fields which
define your system.
Figure 38 System Screen 1, During Standby
Diagnostic
Diagnostic
Diagnostic Mode
Mode
Mode
Select this box to display flow rate and pressure for
each pump on the
.
Component
Component
Component A
A
A Pumps
Pumps
Pumps
Enter the number of Component A pumps in your
system.
Component
Component
Component B
B
B Pumps
Pumps
Pumps
Enter the number of Component B pumps in your
system.
Component
Component
Component C
C
C Pumps
Pumps
Pumps
Enter the number of Component C pumps in your
system.
Component
Component
Component D
D
D Pumps
Pumps
Pumps
Enter the number of Component D pumps in your
system.
NOTE:
NOTE:
NOTE: A maximum of four total pumps may be
connected. If there is no Component D Pump, then a
second Component A, B, or C pump may be enabled.
Non
Non
Non---Mix
Mix
Mix Pressure
Pressure
Pressure
Enter a lower pressure for use when not mixing and
spraying (for example during fill or flushing).
NOTE:
NOTE:
NOTE: Low pressure systems may be set 100 psi
(0.7 MPa, 7 bar) lower than target pressure; high
pressure systems may be set 300 psi (2.1 MPa, 21
bar) lower than target pressure.
Solvent
Solvent
Solvent Meter
Meter
Meter
Select this box if your system uses a solvent meter.
The Solvent K-Factor field will then become active.
Solvent
Solvent
Solvent K
K
K---Factor
Factor
Factor
Enter the solvent meter K-Factor.
3A6287E
67
