Graco ProMix 3KS, Installation Manual

Page: 24 / 44

Electrical
24 313881C
Connect ProMix 2KS Fluid
Station to ProMix 3KS Fluid
Station
See F
IG
. 14. At the ProMix 2KS Fluid Station, remove
the knockout and install the solenoid cable strain relief
(supplied). Apply the and (supplied) in the
locations shown.
Connect the 10 ft (3 mm) Communication Cable (Part
No. 123273, green color coded) from the ProMix 2KS
Fluid Station to the ProMix 3KS Fluid Station connector
(J8). See F
IG
. 13, F
IG
. 14, and F
IG
. 15.
Connect ProMix 3KS Solenoid
Wiring Cable to ProMix 2KS
Fluid Station Board
See F
IG
. 14 and F
IG
. 15. The solenoid wiring cable is
shipped attached to the ProMix 3KS Fluid Station. Con-
nect the cable to the ProMix 2KS Fluid Station Board by
threading it through the strain relief port labeled .
Connect the wires to the 2KS board as shown in Table 3
on page 26. Also refer to the System Electrical Sche-
matic on pages 38 and 39.
F
IG
. 13. ProMix 3KS Cabling Diagram
TI14543a
EK
BC
2KS
CCM
PSM
50 ft (15.2 m) IS power cable,
red color coded
10 ft (3.0 m) communication
cable, green color coded
6 ft (1.83 m) color
change cable, yellow
color coded
50 ft (15.2 m) booth control
cable, yellow color coded
See F
IG
. 15 for ProMix 3KS
Cable Connection Detail
See F
IG
. 14 for ProMix 2KS
Cable Connection Detail