Graco Pneumatic PR70, Instructions Manual

Page: 8 / 34

Installation
8 313937A
Installation
Machine Installation
Locate Machine
1. Locate a bench top or open floor area to mechani-
cally mount the machine. Ensure the location has
access to compressed air and AC power and is well
ventilated.
2. Place the machine on the designated location. Allow
the machine to rest on the rubber feet provided.
Mount Machine, if Needed
3. Remove the shield locking screws (110) on both
sides then remove the protective shield.
4. Attach the frame to the selected location by install-
ing fasteners (not provided with unit) through the
four mounting holes. See F
IG
. 3.
Connect Pressurized Air Input
5. Connect a compressed airline to the air inlet (109)
in the back of the machine.
Avoid contact with electrical inter-connects when
connecting electric power to the machine. Avoid con-
tact with Krytox on the pump shaft, PE tank lid, and
PE tank lid gasket. Contact with Krytox causes
flu-like symptoms. Read all manufacturer’s warning
and material MSDS to know the specific hazards of
the material used.
CAUTION
Do not lift the machine by the tanks.
F
IG
. 3: Mounting Holes
ti12713a