Installation
18
312798J
Setup
Ambient Packages
1.
See F
. 1. Attach the blue fluid hose (Z) to the filter
(F) outlet.
2.
Attach the right-hand thread end of the air hose
(AA) to the gun air regulator (T).
3.
Attach the left-hand thread end of the air hose (AA)
to the air whip hose (L).
4.
Attach other end of the air whip hose (L) to the air
inlet at base of gun.
5.
Attach the gun swivel (J) to the gun fluid inlet.
6.
Attach other end of the blue fluid hose (Z) to the
fluid whip hose (K).
7.
Attach other end of the fluid whip hose (K) to the
gun swivel (J).
8.
Apply lens cover to both regulator gauge lenses.
9.
Verify that suction hose fittings are tight.
Heated Packages
Wall Mount Electrical Connections. Follow all
directions and requirements in the Viscon HP Heater
manual 309524.
Cart Mount Hazardous Location Wiring. The heater is
shipped with a fitting that is suitable for wiring in
hazardous locations. Follow all directions and
requirements in the Viscon HP Heater manual 309524.
Do not use the supplied electrical cord, which is
suitable only for non-hazardous location wiring.
Cart Mount Non-Hazardous Location Wiring. See
F
. 4. Replace installed fitting with bushing (80),
shipped loose. Attach strain relief bushing (79). Follow
all directions in the Viscon HP Heater manual 309524 to
connect the 120 V supplied electrical cord (78), or
user-supplied cord for 240V applications.
.
Electrical Housing Access.
Tilt the heater away from the pump for easier access to
the screws on the cover of the electrical housing.
The Viscon HP Heater must be installed by a quali-
fied electrician in compliance with all state and local
codes and regulations.
F
IG
. 4. Cart Mount Non-Hazardous Location Wiring
78
79
80
ti13261a
(120 V only)
Remove
outer two
heater
bracket
screws.
Loosen
inner two
heater
bracket
screws.
ti13358a
Electrical
housing
ti13359a
