PLEASE NOTE: We have done all we can to ensure that when used correctly and in accordance with these instructions the spray gun has a long
and fault-free life. We accept no responsibility for damage caused by the use of incorrect or unsuitable substances, paints or liquids which have
not been thinned correctly or which are not suitable for the surfaces to which they are applied, health hazards arising from a lack of ventilation
when working in confined spaces or equipment which is faulty due to inadequate cleaning of the components after use. If in doubt, test a small
inconspicuous area first. Always read the manufacturer’s instructions before use. Neither our guarantee nor the above statement affects your
statutory rights.
All rights reserved © 2012
INFORMATION ON THE DISPOSAL OF WASTE ELECTRICAL & ELECTRONIC EQUIPMENT KNOWN AS WEEE.
Please do not dispose of tools with your household waste collected by the council. It is your responsibility to dispose
of this type of waste by handing it over to a special designated collection point for recovery and recycling.
This unit is a Class II appliance which means it is double insulated for your protection, no earthing wire is necessary.
If the supply cord is damaged, it must be replaced by our appointed agents.
If you are using an extension lead it must be rated at a minimum of 6 amps and fully unwound. Do not operate with a
mains lead rated at less than 6 amps as this will cause premature failure of the motor which is not covered by the guarantee.
If the plug is cut off from the mains lead, it must be disposed of safely. NEVER under any circumstances insert a plug which is cut off
from the mains lead into a mains socket-outlet.
MAINS CONNECTION
Design Registrations and Patents:
ENG
7
Spray Gun Design Registration
ECD 001096218-0001
CN 200930004457.X
US D609, 778S
Spray Gun Patent
GB 0903275.6
HV3900 Turbine Design Registration
GB 3022947
FR 06/5463
EU 000608856
US D563,503
GUARANTEE and HELPLINE
This product is guaranteed for a period of 12 months against faulty manufacture or materials. It is not guaranteed for industrial or hire purposes.
This guarantee does not affect your statutory rights. For further information or any user advice visit our website www.magnumbygraco.eu.
Graco N.V.
Website
: www.magnumbygraco.eu
CAUSE
ACTION REQUIRED
Paint too diluted
Add undiluted paint
Paint output too high
Reduce the paint output by adjusting the Paint Flow Adjuster (9)
Moving too slowly
Increase speed of application
Spray Trigger held for too long
Release Trigger sooner
Spray Gun too close
Increase the distance between the Spray Gun and the work
surface
Paint too diluted
Add undiluted paint
Paint output too low
Increase the paint output by adjusting the Paint Flow Adjuster (9)
Moving too fast
Reduce speed of application
Spray Gun clogged
Clean the Spray Gun
Spray Gun too far away
Move the Spray Gun closer to the work surface
Paint too thick
Add thinner
Fluid Tip clogged
Clean the Fluid Tip (5)
Pick-up Tube clogged
Clean Pick-up Tube (11)
Air Hose split
Replace air Hose (14)
Grainy paint
Filter the paint
Paint Container almost empty
Refill Paint Container (12)
Spray Gun at an angle
Check that the Pick-up Tube (11) is pointing towards the paint
Air inlet blocked
Check the condition of the Filter (15) and clean if necessary
You move your wrist
Move your fore arm instead
Either too much or not enough paint
Use the Paint Flow Adjuster (9) to control the flow
PROBLEM
The paint drips onto item being
painted
Paint is too thin or irregular
No paint being released
Too much paint in an area
Application
TROUBLESHOOTING
S
P
R
A
Y
G
U
N
hv3900_(H5)_3A1571B_0212_Layout 1 08/02/2012 08:50 Page 7
All manuals and user guides at all-guides.com
