Setup
10
3A0885E
Sprayer Setup
This sprayer arrives from the factory with a small
amount of test material in the system. It is important
that you flush this material from the sprayer before
using it for the first time:
1.
Fill material cup with water and thread onto sprayer.
2.
Put control valve to UP position, then hold trigger in
for 10 seconds.
3.
Put control valve DOWN to spray position.
4.
Reverse spray tip to UNCLOG position and trigger
sprayer into a waste area.
5.
Engage trigger lock and put control valve UP to
release pressure.
6.
Unscrew and remove material cup.
7.
Disengage trigger lock, put control valve DOWN,
hold sprayer slightly above material cup, and pull
trigger to discharge fluid from pump.
8.
Discard material in cup.
NOTE: If the sprayer is angled or tilted too far, the
suction tube will lose contact with the material and
the sprayer will stop spraying.
ti14992a
ti14999a
ti15425a
ti14991a
ti15491a
ti14999a
ti14994a
ti15478a
ti15511a
Summary of Contents for Magnum Pro Compact A15 258861
Page 25: ...Notes 3A0885E 25 Notes...
Page 26: ...Notes 26 3A0885E Notes...
Page 27: ...Notes 3A0885E 27 Notes...
