Graco GrindLazer 25P474, Operation - Repair - Parts

Page: 11 / 74

Setup
3A7600C 11
Handlebar Adjustment
The handlebars are equipped with a high-density
vibration suppression material to reduce operator
fatigue. To adjust the handlebars to a new position for
different height operators, please follow these steps:
1. Using a 9/16” wrench or socket, loosen the bolts on
both sides of the handlebars until the handlebar
moves freely.
2. Stand behind the machine and lightly tap the
handlebar to the desired position.
3. Re-tighten the bolts to 260-300 in-lb (29-34 N•m) to
lock the handlebars into position.
NOTE: Never operate equipment with loose
handlebars. The bolts must be fastened tightly to
ensure the handle is locked into position.
Engine Kill Button (Gas/Propane)
In the event of a malfunction or an accident (such as the
machine operator falling or losing footing), the
GrindLazer is equipped with a corded Engine Kill Button.
Attach the end of the cord to the operator’s belt or wrist,
and snap the clip into place on the button by raising the
top of the Engine Kill Button and inserting the clip into the
gap. If the operator becomes distanced too far from the
machine, the cord will detach from the button and the
machine will stop running. The engine can also be
stopped by pressing down on the Engine Kill Button.