Setup
313440E
3
6.
Connect fluid supply hose (C) from
remote cup fluid outlet to spray
gun fluid inlet.
7.
Fill cup 3/4 full. Install cover.
Screw remote cup cover to secure
it to remote cup.
8.
Refer to spray gun manual 313317
for spraying instructions.
Convert Gun from Siphon Cup to Optional
Remote Cup
1.
Remove air pressure tube
from air stem.
2.
Remove siphon cup cover
from gun
3.
Remove air stem from gun.
4.
Apply medium strength
thread locker to set screw.
Install set screw into gun
flush with gun body.
5.
Connect fluid supply hose.
Note:
To convert from remote cup to siphon cup, reverse
these instructions.
Connect to Electric Supply
Plug sprayer power cord into grounded outlet. Grounding
and Electric Requirements, page 4, manual 313406.
Pressure Relief Procedure
1.
Turn off sprayer.
2.
Unplug sprayer.
3.
Turn out
pressure relief knob (113) one turn. Wait
until pressure is completely relieved before removing
cover. Close knob.
Operation Tips
•
Turn sprayer On a few minutes before spraying to
allow warm-up.
•
Ensure sprayer filter is clean before operating. Clean
filter, page 7, manual 313406.
•
To adjust spray gun pattern, see HVLP
EDGE
Gun
manual 313317.
•
To get proper adhesion, ensure surface is completely
clean.
•
If the remote cup is accidentally tipped over or held at
too great of an angle, fluid may leak into air regulator
and cause damage. Take precautions to avoid this. If
fluid does get into regulator, clean immediately.
•
Only hand-tighten remote cup cover. Excessive tight
ening may damage cover gasket.
•
Always spray with the least amount of pressure
required to provide the desired spray pattern and rate
of application, typically 10 psi. Spraying at pressures
higher than necessary wastes paint and can result in
an orange peel finish.
•
Lightly coat cover threads with petroleum jelly.
ti13151a
ti13149a
ti13152a
ti12915a
WARNING
The optional remote cup remains pressurized
until pressure is manually relieved. To reduce
the risk of serious injury from pressurized fluid
or accidental spray from gun, always
relieve
pressure
in the remote cup before loosening
or removing the cover. Also,
relieve pressure
if the fluid nozzle clogs; and before cleaning,
checking or servicing equipment.
Sparks can be expected during normal operation of
motor. These sparks can ignite fumes from flammable
liquids, dust particles, and other flammable sub
stances in the spray area.
•
Use additional hose if necessary, and ensure the
sprayer is operated in clean, dry, well ventilated
area.
•
Never use sprayer inside spray booth.