![background image](http://html.mh-extra.com/html/graco/ecoquip-eq200t/ecoquip-eq200t_operation-repair-and-parts_2251537012.webp)
9.
Align the bung handle with the pin slot, and then
firmly push and turn the handle 90° after the pin
is below the bracket slot. Proper engagement of
the pin will hold the bung down until it is released.
10. Add 10 gallons (30 liters) of fresh water to
the pot. Wear appropriate personal protective
equipment, including an appropriately fit-tested
government approved respirator suitable for the
dust conditions. Add abrasive material (minimum
four bags, maximum ten 50 lb (23 kg) bags of
high-mass abrasive, or eight 50 lb (23 kg) bags
of low mass abrasive).
1
2
10 gal
(30 L)
200-500 lb
(90-227 kg)
11. Use a garden hose or the rinse hose to wash the
abrasive into the pot and clear any abrasive from
the bung and bung seal.
12. When the water level reaches the bung seal,
rotate the handle to release the bung pin (this
will cause the bung to pop up against the seal
and close the bung).
13. Turn the selector valve to FILL.
NOTE:
NOTE:
NOTE: The water pump should begin cycling. If
not, open the pot pressure regulator enough to
cause the pump to run at 60 cpm.
NOTE:
NOTE:
NOTE: The auto vent/purge valve will allow all
of the air trapped in the top of the pot to vent.
When air stops venting, the pot pressure gauge
will start to register pressure.
12
334666B