Operation
8
3A3005C
Starting Pump
1.
Turn on hydraulic power supply.
2.
Open return line shut-off valve (H) first, then slowly
open the hydraulic supply shut-off valve (L).
3.
Adjust flow control valve (R) to limit the hydraulic
flow to no more than 3 gpm (11 lpm), which is
approximately 60 cycles per minute.
4.
Adjust pressure reducing valve (N) to increase
hydraulic inlet pressure from 50 to 900 psi (0.34 to
6.2 MPa, 3.4 to 62.1 bar).
•
Increasing inlet pressure, increases outlet pres-
sure.
•
Decreasing inlet pressure, decreases outlet
pressure.
5.
Open drain valve while priming pump.
6.
When pump is primed, close drain valve.
Always use lowest pressure possible to obtain desired
results. This reduces pump wear.
If the Pump Leaks at the Fluid
Fittings
Tighten fittings (1, 5, 60) which are self-sealing and
have replaceable o-rings. If leaking persists, change
o-rings.
Shutdown
Relieve pressure
, page 7, whenever you shutdown.
Maximum Working Pressures
To reduce the risk of serious injury, including fluid
injection and splashing in the eyes or on the skin,
which may be caused if a component ruptures:
•
Never exceed
900 psi (6.2 MPa, 62.1 bar) Maxi-
mum Hydraulic input Pressure
to the reciprocator.
•
Never exceed
10,000 psi (69 MPa, 689 bar) Max-
imum Outlet Pressure
from the displacement
pump.
•
Accessories added to the pump fluid outlet side
should have at least a
10,000 psi (69 MPa, 689
bar) Maximum Working Pressure.
•
Read and understand
COMPONENT RUPTURE
HAZARD
instructions, page 7.
F
IG
. 2
sealing
fitting (1, 5, 60)
reciprocator
o-ring
(1a, 5a,60a)
ti04478
