12
CarSeat.se
9. Placement of child: Push button (A) to extend car seat harness. Pull harness as far back as
possible (B). Push red button on the lock (C) to open harness and pull to respective side (D).
Pull crotch strap with lock and protective pad forward (E). Place child in car seat (F) with
crotch strap between legs. Pull together both harness straps (G) and push them into the
lock (H) with a "click". Adjust harness height as needed (see picture 2). Tighten belt by
pulling strap (I) in front . Appropriate tension has been reached when two adult fingers
can fit between belt and child. To release, push button (A).
10. To reach the right angle, support leg
should be extended completely before base
is placed in car. If DuoLogic is installed in
front seat, vehicle seat back should be
completely upright.
11. Place base in desired location. To make
installation easier, temporarily slide front
seat(s) all the way forward.
12. Your vehicle manual should show where
ISOFIX mountings are located. Lift the red
lock(A) and slide base forward (B) so yellow
arrows point against each other (C).
13. Push the base towards the ISOFIX
mountings. Connection should be made
with an audible "click". Included ISOFIX
guides (small plastic details around ISOFIX
mountings) make connection easier.
INSTALLATION MANUAL
How to use DuoLogic
INSTALLATION MANUAL
With ISOFIX
