Graco Duet Sway, Owner'S Manual

Page: 8 / 65

14 15
EN INSTRUCTIONS
Parts List
1
Check that you have all the parts for
this model
BEFORE
assembling your
product. If any parts are missing, call
Customer Service.
No tools required.
Head Support
2
DO NOT use any other accessories
with this product.
Only use this head support on this
swing. Never use this head support
on any other product.
Modes of Use
Swing Mode:
3
DO NOT
place seat backwards on the
frame.
To Assemble Seat
5
Insert wire into the seat frame as
shown.
6
Insert the seat legs into the seat
frame on each side.
7
Connect the 4 snaps together at the
foot end.
8 Insert seat legs into the rocker tubing
base.
9
CHECK to make sure it is attached by
pulling up on it.
10 Insert the seat pad straps into the
outer slots of the rocker mount.
11 Connect the remaining snaps on the
back side of seat pad.
8
To Assemble Toybar
12
Insert toybar into opening in seat and
snap it to the seat frame.
13
14 Attach toys as shown.
To Assemble Swing Frame
15
Insert the frame’s feet into the main
frame.
16 Check that buttons are visible.
17
Insert motor housing (+plastic cover)
into the leg assembly.
18 Insert nuts (A) and screw in bolts (B).
Slide the plastic cover down and snap
onto leg assembly.
19
To Attach Rocker to Swing Frame
20
Hold rocker by sides and attach rocker
to mount on swing frame.
21
Note: Rocker can be placed on swing
frame facing any of 3 directions (front,
left and right
22
). Rocker cannot be
placed backwards on the frame.
To Remove Rocker
23
To use as rocker, step on swing frame,
tilt the rocker slightly towards the
motor housing and lift rocker off.
To Secure Child
WARNING
Falling Hazard: Always use the seat belt.
24 To open, press button on buckle to
release the waist straps.
25 To close, slide shoulder strap
connectors to waist straps and insert
into buckle.
26
Use slide adjuster at shoulder and
waist for tighter adjustment.
27 When changing shoulder strap slots,
MAKE SURE shoulder straps are going
through same slots in seat pad.
28 The shoulder straps must go into the
slot that is even with or slightly above
the child’s shoulders. Avoid twisting
straps.
To Recline Rocker
29
To recline, squeeze the recline handle
and move into 1 of 3 positions.
30
To Use Wall Plug
WARNING
DO NOT place product near water or
moisture. Do not use the product near
possible wet areas, such as a bathtub,
shower, wash basin, sink, laundry tub,
swimming pool, wet basement, etc.
DO NOT use the AC adaptor if it has been
exposed to liquids, has been dropped, or
is damaged.
Protect the power cord. Place it so it is
not walked on or pinched by furniture or
other items.
WARNING
Strangulation Hazard: Keep this cord out
of the reach of children.
31
DO NOT
use with an extension cord.
Use only power cord provided.
To Start Swing
WARNING
To avoid serious injury from falling or
sliding out, ALWAYS use restraint system.
After fastening buckles, adjust belts to get
a snug fit around your child.
32
TO TURN SWING ON:
Rotate the
speed dial clockwise, and lightly push
the swing to get it started. The LED
light is illuminated when the swing
is on, and not illuminated when the
swing is off. Observe the swinging
motion for a minute. It takes up to
a minute for the swing to reach the
correct setting. Change setting if
needed by moving the dial clockwise
for faster speeds or counter-clockwise
for slower speeds.
TO TURN SWING OFF:
Turn dial
counter-clockwise until it “CLICKS”
into the “OFF” position.
The seat may be stopped at any
time the motor is running without
damaging the motor.
To Use Vibration
33 Remove battery lid, found under foot
end of seat, with a key and insert
1-D (LR20-1.5V) battery in module.
Replace lid.
34
Vibration:
Turn to one of two
settings.