Torque Instructions
Torque Instructions
If fluid cover or manifold bolts have been loosened,
it is important to torque them using the following
procedure to improve sealing.
NOTICE
Do not over-torque. Tightening the bolts too tight
will damage the pump.
NOTE: Always completely torque fluid covers before
torquing fluid manifolds.
1. Remove the protective bolt covers (37) with
a screwdriver. Carefully work the screwdriver
under the lip of each cap and gently pry it off.
2. Start all fluid cover screws a few turns. Then, turn
down each screw just until head contacts cover.
3. Turn each screw by 1/2 turn or less working in a
crisscross pattern to specified torque.
4. Repeat for fluid manifolds.
Assembly
Torque
Re-Torque
Fluid Covers
20 in-lb (2.3
N∙m)
15 in-lb (1.7
N∙m)
Fluid
Manifolds
15 in-lb (1.7
N∙m)
10 in-lb (1.1
N∙m)
Fluid Cover Screws
Fluid Manifold Screws
22
334792E
Summary of Contents for ChemSafe 205
Page 23: ...Notes Notes 334792E 23 ...
