Preparation
8
3A4442F
Preparation
Grounding
This sprayer includes a ground wire with an
appropriate ground contact. The plug must
be plugged into an outlet that is properly
installed and grounded in accordance with all
local codes and ordinances.
Do not modify the plug provided; if it does not
fit the outlet, have the proper outlet installed
by a qualified electrician.
Power Switch
Select 15A or 20A depending on your circuit
rating. 110V units require 100-120 VAC,
50/60 Hz, 15 – 20A, 1 phase
Select 10A or 16A depending on your circuit
rating. 230V units require 220-240 VAC,
50/60 Hz, 10 – 16A, 1 phase
Extension Cords
Use an extension cord with an undamaged
ground contact. If an extension cord is
necessary, use a 3-wire, 12 AWG (2.5 mm
2
)
minimum.
NOTE:
Lighter gauge or longer extension
cords may reduce sprayer performance.
Generator Requirements
5000 W (5 kW) minimum.
ProGuard
The ProGuard protects the sprayer against
high and low voltage spikes. If the sprayer is
plugged into a power source that goes too
low or too high the sprayer stops operating.
VIBRA-FLO Shaker
(6200/8200 models)
The hopper shaker vibrates the hopper which
assists in moving the material down to the
pump inlet at the bottom of the hopper.
Bag Roller (Optional)
Bags of material can be difficult to empty. A
bag roller provides a quick and easy way to
empty material bags directly into the hopper.
Mixing Material
NOTE:
Correct material mixture is essential.
The pump and spray gun will not operate if
the mixture is too thick. Use water-based
materials only.
1.
Mix the material and water in a
separate container.
Dry Mix
Carefully mix texture material and water
according to manufacturer instructions
on bag.
The equipment must be grounded to
reduce the risk of static sparking and
electric shock. An electric or static spark
can cause fumes to ignite or explode. An
improper ground can cause electric shock.
A good ground provides an escape wire for
the electric current.
ti2496c
40 lb.
TEXTURE MIX
5 GAL
