background image

5

808-9-98

6

8

7

PARTS LIST

CHECK that you have all the parts listed below

BEFORE assembling your stroller.

If any parts are missing, call Customer Service

at 1-800-345-4109.

THIS PRODUCT REQUIRES ADULT ASSEMBLY.

No tools required for assembly.

Frame

Rear wheel (2)

Cap 

(2, 1 extra)

Front wheel

assembly (2)

To Assemble Front Wheels

To prevent 

serious injury or death 

from choking, remove and 

IMMEDIATELY discard plastic 

end caps on the front leg pins.

Step 1.

Remove 

and discard

the plastic 

end caps on the front leg 

pins. Line up pin with a wheel 

assembly as shown.

Plastic snap inside wheel

mount must be away from pin.

Push wheel assembly onto pin 

until it snaps into place.

Step 2.

Repeat for other wheel assembly.

NOTE: Pull firmly on each wheel assembly to be 

sure the wheel assemblies are securely attached.

End cap

To Assemble Rear Axle

Rear legs

Brake levers

point toward

you

Step 1.

Turn stroller over as pictured above.

Step 2.

Position rear axle assembly as shown.

Step 3.

Start both brackets onto leg tubes at the same time.

Step 4.

Push both brackets on until plastic tabs snap into the slots

on the legs.

Step 5.

Pull firmly on each bracket to be sure the brackets are

securely attached.

To Assemble Rear Wheels

Place one rear wheel, red retainer, and white cap on one end

of rear axle 

in order

as shown below. Push red retainer onto

axle BEFORE attaching white cap. Repeat on other side.

Snap red retainer into axle

groove. Then snap cap

over red retainer as shown.

Be sure cap is snapped securely over red retainer.

To Attach Seat

Step 1.

Set the stroller frame upright.

Step 2.

Line up notches on sides of seat with plastic brackets on

frame. Lower seat onto frame until it snaps into brackets.

Seat can be installed facing either direction. 

Pull up on

each side of seat to be sure it is securely attached.

Step 3.

To remove seat to reverse position

or for cleaning, squeeze the levers

on both sides of seat and lift.

DO NOT lift, reverse or carry the seat

while child is in the seat. 

Boot 

(on certain models)

Rear axle assembly

Retainer 

(2, 1 extra)

Seat 

Canopy

Rear

axle

Retainer (red)

Wide end

toward wheel

Wheel

Cap (white)

Attach AFTER

retainer is on axle

Spokes

toward

inside

To Adjust Back

To raise or recline seat back,

pull up the plastic handle at

back of seat and adjust seat

back to desired position.

Seat back can adjust to five

different positions.

To Assemble Canopy

Step 1.

Position canopy over 

back

of stroller frame as shown.

Align the ends of the canopy

mounts with the openings in

the seat covering. Push the

canopy mounts into the slots

until they snap in place.

Step 2.

To remove canopy, push in

the button 

hidden under 

the padding directly under

one canopy mount

, and 

pull the canopy mount out 

of the slot. Repeat on other

side.

Button under

padding below

canopy mount

To Adjust Canopy

Push or pull canopy to desired 

position. 

Locking

latch

To Unpack Stroller

Step 1.

Flatten stroller carton to protect floor. Slide seat out

from frame and set it aside.

Step 2.

Open stroller frame 

on carton by lifting 

handle until locking 

latches on both sides 

are locked as shown.

OR

Reviews: