Graco 3A0239F, Instructions - Parts Manual

Page: 3 / 30

Models
3A0239F 3
Models

The Residual Current Device (RCD) must be rated at 300 mA if it is installed.
Basic modules provide power to the control dispense system only.
Fully loaded modules provide power to the control dispense system, four heat zones, and two feed tanks.

See 400 V Power Requirements .
400 V Power Requirements
• 400 V systems are intended for International voltage
requirements. Not for voltage requirements in North
America.
• If a 400 volt configuration is operated in North Amer-
ica, a special transformer rated for 400 V (“Y” con-
figuration (4 wire)) may be required.
• North America mostly employs a 3 wire or Delta
configuration. The two configurations are not inter-
changeable.
Description
Maximum
Amperes Description
HFR Power Distribution Modules
230V, 1 Phase, Basic 55 A 200-240VAC, 1 phase, 50/60 Hz
2 wire and PE
230V, 1 Phase, Fully Loaded 116 A
230V, 3 Phase, Basic 29 A
200-240VAC, 3 phase
Δ
, 50/60 Hz
3 wire and PE
230V, 3 Phase, Fully Loaded 73 A
400V, 3 Phase, Basic

55 A 380-415VAC, 3 phase Y, 50/60 Hz
3 wire, neutral, and PE

400V, 3 Phase, Fully Loaded

63 A

VRM Power Distribution Modules
230V, 3 Phase, Basic 60 A
200-240VAC, 3 phase
Δ
, 50/60 Hz
3 wire and PE
230V, 3 Phase, Fully Loaded 105 A
400V, 3 Phase, Basic

55 A 380-415VAC, 3 phase Y, 50/60 Hz
3 wire, neutral, and PE

400V, 3 Phase, Fully Loaded

75 A

VPM Power Distribution Modules
230V, 3 Phase 75 A
200-240VAC, 3 phase
Δ
, 50/60 Hz
3 wire and PE
400V, 3 Phase

55 A 380-415VAC, 3 phase Y, 50/60 Hz
3 wire, neutral, and PE
400V, 3 Phase

55 A
