Operation
14
3A8307D
Battery Installation
NOTE: The reference numbers in the following
instructions refer to and F
, page 7.
2. Remove the impact guard (37).
3. Remove the four (4) screws (9) from the meter
housing (10), and remove the electronics bezel (1).
4. Locate the battery pack and remove the batteries
(36).
5. Dispose of the batteries according to local
regulations for battery disposal.
6. Insert new batteries as shown on the battery holder
(negative and positive positions). Press down
firmly.
7. Reinstall the battery pack.
8. Position the wires as shown in F
. 9, to minimize
pinching the wires between the meter housing and
the bezel housing.
9. Inspect the bezel seal (2) for damage. Replace, if
needed.
10. Place the electronics bezel (1) onto the meter
housing (10).
11. Reinstall the four (4) screws (9), tightening the
screws in a diagonal pattern to 15 - 25 in-lb (1.7 -
2.8 N•m).
F
IG
. 8
9
10
36
2
1
37
