Repair
26
3A5379B
9. Install the new fan assembly. To reattach the fan
assembly, slide the cover into the slots for tabs
located on the junction box side, and gently push
down the far end. Apply thread locker and use the
supplied fasteners and washers. Torque to 15 - 20
ft-lb (20 - 27 N•m).
10. Route the wires through the fan cord grip (C1)
attached to the driver (not the junction box (BC)).
11. Reattach the ground wire to the grounding screw.
Tighten the ground screw. See F
IG
. 21.
12. Use a ferrule to connect each fan wire to one of the
two wires coming out of the motor grommet. Then
attach one wire set into the disconnect box location
1L1, and the other wire into location 5L3. See F
IG
.
21.
13. Gently tuck the wires back into the junction box (BC)
around the disconnect block (BD) and reinstall the
junction box cover (BA). Replace the two screws
(53) and washers, then tighten. See F
IG
. 19, page
24.
14. Tighten cord grip attached directly to driver assem
-
bly.
F
IG
. 24: Fan Assembly Installation
NOTICE
If wires get pinched when the screws are tightened,
damage will occur. Make sure all wires are routed
correctly before installation.
WLE
C1
WLD
/
/
/
7
7
7
