Installation
3A5379B
11
4. Insert the power cord through the cord grip and into
the junction box.
5. Attach the ground wire to the ground terminal inside
the junction box as shown in F
IG
. 7.
6. Refer to F
IG
. 6 and connect the wires from the
power cord into terminals 2T1 and 6T3.
NOTE:
Do not attach the ground wire to the grounding
lug locknut on the outside of the electric driver. Located
below the fan wiring cord grip, the grounding lug locknut
is used for grounding the pump lower. See
Grounding
on page 9.
7. Place the fan wires and other power wires into the
open area on either side of the disconnect block
(BD) as space permits.
8. Reinstall the junction box cover and disconnect
switch (K) using the two screws and washers
removed in step 2.
9. Tighten the cord grip to securely hold the power
cord in the junction box.
Install Vented Oil Cap Before
Using Equipment.
The driver gear-box is shipped from the factory pre-filled
with oil. The temporary unvented cap (PX) prevents oil
leaks during shipment. This temporary cap must be
replaced with the vented oil cap (P), supplied with the
equipment, before use.
NOTE:
Prior to use, check oil level. Oil level should be
half way up the sight glass.
F
IG
. 7: Connect Power
NOTICE
Make sure all wires are routed correctly before instal
-
lation. If wires get pinched when the screws are tight
-
ened, damage will occur.
For clarity, tan wires and
other power wires not shown
Cord Grip
F
IG
. 8: Tighten Cord Grip
F
IG
. 9: Unvented and Vented Oil Caps
PX
P
ti31010a
