Setup
3A4586E
9
Setup
Accessories are available from Graco. Make certain all
accessories are sized and pressure-rated to meet your
system requirements.
•
Verify that the motor voltage corresponds to proper
electrical supply. Before plugging motor into power
supply, make sure the motor switch is in the OFF
position.
•
Before operation, confirm all pump connections are
properly tightened.
•
Before starting the pump, confirm the discharge
hose is securely fastened to the receiving vessel in
order to prevent splashing.
Pre-Start Checklist
Verify each of the following items before starting the
pump.
•
DEBRIS: Ensure that the fluid supply is free of dirt,
debris, and any contaminants.
•
HOSE MATERIAL: Check that the hose material is
compatible with the fluid being pumped. Consult
your Graco distributor for available hose materials.
•
FASTENERS: Check that all fasteners are properly
tightened.
•
LEAKS: Check the connections on the fluid outlet to
be sure there are no leaks.
Flush Before First Use
The sanitary pump was assembled using sanitary lubri-
cant on moving parts and was tested in water. Flush the
pump thoroughly with an appropriate cleaning solution,
and disassemble and sanitize the parts before using the
pump. See Flushing Procedure, page 14. Check
national, state, and local codes for specific limitations.
Tighten Connections
Before each use, check all hoses for wear or damage.
Replace as necessary. Check that all connections are
tight and leak-free.
