All written and visual data contained in this document reflects the latest product information available at the time of publication.
Graco reserves the right to make changes at any time without notice.
Original instructions. This manual contains English. MM 3A6709
Graco Headquarters:
Minneapolis
International Offices:
Belgium, China, Japan, Korea
GRACO INC. AND SUBSIDIARIES • P.O. BOX 1441 • MINNEAPOLIS MN 55440-1441 • USA
Copyright 2018, Graco Inc. All Graco manufacturing locations are registered to ISO 9001.
www.graco.com
Revision
B
,
May 2019
7. Connect the red inlet transducer cable to connector
seven on the inlet transducer monitor (A), and
connect the blue inlet transducer cable to connector
six on the inlet transducer monitor (A).
8. Connect the CAN cable (B) from either CAN
connection on the inlet transducer monitor (A) to
CAN connector 1 or 2 found on the motor.
9. Secure the CAN cable (B) to the frame using the
cable ties (H) provided, and route it through the
protected opening as shown in F
10. Re-install the pump yoke shroud (J) and frame
cover (K) onto the EFR system.
11. The transducers will be automatically recognized
upon connection.
Graco Information
Sealant and Adhesive Dispensing Equipment
For the latest information about Graco products, visit
www.graco.com
.
For patent information, see
www.graco.com/patents
.
TO PLACE AN ORDER,
contact your Graco distributor, go to www.graco.com, or call to identify the nearest
distributor.
If calling from the USA:
1-800-746-1334
If calling from outside the USA:
0-1-330-966-3000
F
IG
. 5
B
H
