- This manual contains kit installation instructions only -
Motor Kit: 257570
,
16F290, 16F393
Pressure Relief Procedure
Important Safety Instructions
For detailed sprayer information and warnings, see
Operation manual 313381 included with sprayer.
To help prevent injection injuries, follow this procedure
when you stop spraying and before you service or clean
the sprayer, remove parts, or repair leaks.
1.
Turn power switch OFF. Unplug sprayer.
2.
Turn Spray/Prime valve to PRIME to relieve pressure.
Turn pressure control knob left (counterclockwise) to
minimize pressure.
3.
Trigger gun.
4.
Put trigger safety in safety ON position.
NOTE: Leave Spray/Prime valve in PRIME
position until you are ready to spray again.
If you suspect that the spray tip or hose is completely
clogged or that pressure has not been fully relieved after
following the steps above, VERY SLOWLY loosen the tip
guard retaining nut or hose end coupling to relieve pressure
gradually. Then loosen it completely. Clear the tip or hose
obstruction.
313586B
Instructions
Motor Kit for Tradeworks 150
™
and Tradeworks 170
™
Sprayers
ti10220a
ti11868a
ENG
