Graco 24Y858, Installation And Operation Instructions Manual

Page: 8 / 36

Installation
8 3A2592M
Installation
General Installation Information
NOTE: Cord reels perform best when arm allows the
accessory cord to pull straight off the spool as shown in
F
IG
. 2.
NOTE: Always use 4 large flat washers with 4 bolts to
mount the reel base to any surface.
All Models
Select the reel bank mounting location.
• For high ceilings, suspend a suitable support
structure for the reels, so the accessory cords
will be long enough to reach your service area.
1. Select a location to mount the cord reel.
2. If cord reel has been previously installed, discon -
nect cord reel from power source by unplugging
power cord from outlet.
3. Determine the desired position of the roller support
arm (a) (F
IG
. 3).
• The cord reel is factory-assembled and
shipped with the roller support arm (a) in posi -
tion AA* (F
IG
. 3). If that position is desired, skip
step 4.
4. To reposition roller support arm to any other posi -
tion than the Ship Position (AA):
a. Secure spool against reel base with
C-Clamp.
b. Remove 4 nuts (b) and rotate arm to desired
position, BB, CC, DD, EE, or FF.
c. Check pawl to make sure it is not wedged.
d. Replace 4 nuts (b) and tighten securely.
To reduce the risk of injury from electric shock and
fire and explosion:
• Before installing, adding accessories or
performing any maintenance on the cord reel,
verify and/or disconnect cord reel from power
source.
• When installing a cord reel above a hazardous
location the reel must be mounted at such a
height that the lamp guard cannot reach within
18 inches of the floor.
F
IG
. 2
Overhead Installations
F
IG
. 3
a
CC
BB
b
DD
EE
FF
AA*