Install
Install
Install the
the
the Frame
Frame
Frame
Use these steps if you want to install the kit onto the
PD2K stand using frame (13).
1.
Follow the steps in
Before Installing the Kit, page 9
2.
Install the frame (13) to the upright of the PD2K
stand (A) using three screws (16) and nuts (18).
3.
Install the back panel/bracket assembly (B) in the
outermost position on the frame (13), to allow
clearance for the color change manifold (C).
Fasten the panel to the frame (13) using four
screws (15) and nuts (18). Install the top screws
from the front and the bottom screws from the
back.
NOTE:
NOTE:
NOTE: The illustration shows a resin (70cc) pump
expansion kit being installed on the left (color) side
of the PD2K proportioner. The pump control module
and dual grommet (11) are preassembled at the
factory so the cable (8) is facing to the right, allowing
easier access to connections inside the PD2K
electrical control box (D).
Install a catalyst (35cc) pump expansion kit on the
right side of the proportioner, with the pump control
module and dual grommet (11) preassembled in the
opposite direction so the cable (8) is facing to the left.
Figure 2 Install the Frame and Pump
10
332456D
