![background image](http://html1.mh-extra.com/html/graco/24n468/24n468_instructions-manual_2251210019.webp)
Operation
3A2960G
19
Timer Mode: Pump ON
The display indicates the amount of time remaining in
the pump cycle, counting down the Pump ON time value
(see Time Control (on:ti) ON Setup page 14).
•
The Pump output is enabled.
•
Pump ON time is shown in MM:SS
(minutes:seconds).
Timer Mode: Pump OFF
The display indicates the amount of time remaining in
the pump OFF cycle, counting down the Pump OFF time
value (see
, page
16).
•
The Time OFF LED illuminates and the pump output
is disabled during the Pump OFF time.
•
Pump OFF time is shown in HH:MM (hours:minutes)
or MM:SS if the time remaining is less than an hour.
Series F and Later
To enter TEST MODE:
1.
Press the LEFT and
RIGHT arrow buttons
together for three (3)
seconds.
2.
The unit enters a sequence of ON for the
programmed on time, and OFF for one (1) minute
until TEST MODE is exited or 10 sequences are
completed. If pressure or cycle feedback is
selected, it will change to OFF when the SETUP
parameters are met. If the amount of cycles or
pressure is not met, it goes into the corresponding
alarm condition.
3.
To exit TEST MODE, press the
RESET button once.
Alarm Operation
When an alarm situation occurs:
•
pump operation is immediately
disabled,
•
the front panel Alarm LED illuminates,
•
an error code displays
•
an audible alarm sounds
•
the alarm output contact activates
Press the Reset button once to clear
buzzer; press and hold for 3 seconds
to clear alarm and switch controller to
OFF MODE.
See
Table, page 20 for
additional information related to alarms and alarm mes-
sages.
Summary of Contents for 24N468
Page 12: ...Installation 12 3A2960G FIG 10...