Contents
Models................................................................ 2
Safety Information .............................................. 2
General Information ........................................... 2
Setup Procedure ................................................ 3
Cartridge Replacement ...................................... 4
Cleanup .............................................................. 4
Troubleshooting ................................................. 5
24H686 Parts ..................................................... 6
24H683, 24H685 Parts ...................................... 8
24U892, 24U893 Parts ...................................... 10
24U894, 24U895 Parts ...................................... 12
Hall Sensor Information ..................................... 14
Graco Standard Warranty .................................. 15
Graco Information .............................................. 15
Models
Part
Description
Maximum Fluid Outlet
Maximum Air Inlet
24H685
32 oz Cartridge Retainer
80 psi (410 kPa, 4.1 bar)
100 psi (0.7 MPa, 7 bar)
24H686
20 oz. Cartridge Retainer with Drive Cylinder
80 psi (410 kPa, 4.1 bar)
100 psi (0.7 MPa, 7 bar)
24H683
20 oz Cartridge Retainer
80 psi (410 kPa, 4.1 bar)
100 psi (0.7 MPa, 7 bar)
24U895
12 oz Cartridge Retainer with Drive Cylinder
80 psi (410 kPa, 4.1 bar)
100 psi (0.7 MPa, 7 bar)
24U893
12 oz Cartridge Retainer
80 psi (410 kPa, 4.1 bar)
100 psi (0.7 MPa, 7 bar)
24U894
6 oz Cartridge Retainer with Drive Cylinder
80 psi (410 kPa, 4.1 bar)
100 psi (0.7 MPa, 7 bar)
24U892
6 oz Cartridge Retainer
80 psi (410 kPa, 4.1 bar)
100 psi (0.7 MPa, 7 bar)
Safety Information
This product should be used only by employees who have been given adequate training on operations
and safety procedures as set forth in this manual.
Read all applicable manuals completely before operating.
Warning:
Contents are under pressure. Wear safety glasses at all times.
General Information
The cartridge retainer with regulator is a pressurized aluminum material reservoir specifically designed to
accommodate a SEMCO material cartridge. Inlet air must be clean and dry.
It is shipped complete with the following:
•
Cartridge retainer with regulator
•
Air shut off slide valve, and return flow control valve.
•
Mounting bracket and clamp for horizontal/vertical mounting
•
Two 3-foot (1 meter) sections of pneumatic air line with a 1/4 MNPT end.
•
Operating manual
2
Summary of Contents for 24H683
Page 14: ...Hall Sensor Information 14 ...
