![background image](http://html1.mh-extra.com/html/graco/24g952/24g952_instructions-parts-manual_2252751013.webp)
Installation
3A1299K
13
Install Tank Stand
1. Install the tank stand no more than 6 ft. (1.8 m) from
the rear of the material pumps on the HFR or VRM
system.
2. Anchor the tank stand to the floor. (Suggested
anchors: McMaster-Carr anchor, 92403A400.) See
3. Plug the tank stand power cable into the bottom of
the HFR or VRM power distribution box.
4. Plug the tank stand CAN cable into the CAN splitter
inside the distribution box.
NOTE: Tank stands are configured for the A (Red)
side. Adjust rotary switch setting if tank is being
used on B (Blue) side.
Install Level Sensors
1. Turn main power off.
2. Relieve tank air pressure. See
3. Drain tanks below the lowest level sensor well.
If installing high temperature level sensors:
4. Apply PTFE paste and PTFE tape to the male
threads of the level sensor.
5. Being careful to not cross-threads, thread the level
sensor (CB) into the corresponding tank port.
6. Plug the sensor cable adapter into the level sensor.
7. Plug the sensor connector (CD) into the level sensor
adapter.
8. Plug the sensor connector into the connector on the
FCM.
If installing low temperature level sensors:
NOTE: For proper level sensor function, the tip of
the level sensor well must protrude at least 1/8 in.
into the tank (C).
9. Route each level sensor (H) wire (J1, J2, J3)
through the corresponding well nut (CC). See F
for level sensor assembly view. See F
locations on tank.
NOTICE
To avoid improper operation, ensure the mark (dot
or arrow) found on the hex of the level sensor is
pointing towards the top or bottom of the machine
after tightening.