3A1307A
3
8.
Connect blue and yellow cables (21) from the winch
terminals to blue and yellow color-coded terminals
on winch switch terminal.
9.
Disconnect ground terminal on battery. Connect red
and black cables (21) to red and black color-coded
winch switch terminals. Attach the red cable from
the winch control connector and power cable from
the winch switch to the positive terminal on the bat-
tery. Then connect the black cable to the ground ter-
minal on the battery. See
Wiring Diagram,
page
10. Connect the green plugs from the winch control con-
nector and the winch switch as showed in
Wiring
Diagram,
page
11. Plug in winch controller (19) to the connector and
route to the cab of the vehicle. Properly protect and
secure all wires to keep from damaging them during
every day use.
12. Adjust the winch arm (3) so it is in line with the lifting
point on the gun arm. Ensure the winch arm is
secured by pinning it and tightening the extension
clamp (15).
13. Use the buttons on the controller to lower the winch.
Connect the winch hook (22) to the lifting point on
the gun arm.
14. When transporting the RoadPak system, the gun
arm must be properly stowed (see manual 3A1214)
and the winch arm must be adjusted to fit within the
width of the vehicle.
ti17111a
21
ti17112a
ti17114a
22