Setup
309907P
9
Pressure Relief Procedure
1
Turn off air supply to pressure pot or gun
2
Turn off turbine sprayer.
3
Remote Pressure Pot:
Turn
out
pressure relief
knob (113) one turn. Wait until pressure is
completely relieved before removing cover. Close
knob.
Spray Gun Cup:
Note:
Elevate spray gun and pull trigger. This will
allow fluid in hose to drain back into remote
pressure pot.
a. Unlatch cup cover; loosen or remove cup from
cover to relieve pressure.
b. Clean spray gun and cup as instructed in
HVLP-Turbine Gun manual 309205 (310750
Korean)
F
IG
. 3
Accessory Remote Pressure Pot
1
Follow Pressure Relief Procedure, page 9.
2
Remove pressure pot cover and fill. Secure cover.
Note:
Lightly coat cover threads with petroleum jelly.
Note:
Always spray with the least amount of pot pres-
sure required to provide the desired spray pattern and
rate of application, typically 10 psi. Spraying at pot pres-
sures higher than necessary wastes paint and can result
in an orange peel finish.
Fill Cup or Remote Pressure Pot
Spray Gun Cup
Fill cup 3/4 full to keep air pressure tube clean. Install
cover. Latch the under-cup cover (H) to secure it to cup.
Fig. 4. The overcup (J) has threads to secure it in place
on the cup.
F
IG
. 4
WARNING
The accessory remote pressure pot remains
pressurized until pressure is manually relieved.
To reduce the risk of serious injury from pressur-
ized fluid or accidental spray from gun, always
relieve pressure
in the pressure pot before loos-
ening or removing the cover. Also,
relieve pres-
sure
if the fluid nozzle clogs; and before
cleaning, checking or servicing equipment.
TXDUW
WLD
CAUTION
If the 2-quart remote pressure pot is accidentally
tipped over or held at too great of an angle, fluid may
leak into air regulator and cause damage. Take pre-
cautions to avoid this. If fluid does get into regulator,
clean immediately.
CAUTION
Only hand-tighten pressure pot cover. Excessive tight-
ening may damage cover gasket.
WARNING
The spray gun cup is pressurized by the gun’s air
supply. To reduce the risk of serious injury from
pressurized fluid or accidental spray from gun,
always turn off the air supply to the gun before
removing the spray gun cup.
02845
H
J
