Graco 204536, Instructions - Parts Manual

Page: 6 / 16

Installation
6 306565K
Preparing the Agitator for Use
1. Remove the nut (5), lockwasher (4), blade (10), and
pin (6) from the shaft (12 or 13). See Parts, page
12.
2. Install the agitator on the container cover by
inserting the shaft through the cover bung hole.
3. Position the air motor so the air line (D) can be
attached easily and will not obstruct any other
system components. See F
IG
. 2.
4. Two recessed areas are machined into the air motor
hub. To secure the air motor to the cover, tighten a
cover setscrew into one of the recessed areas.
5. Install the pin (6), blade (10), lockwasher (4), and
nut (5) onto the agitator shaft (12 or 13). Apply
anaerobic sealant and torque nut (5). See Parts,
page 12.
Model 204536
Screw the straight tube fitting (14a) into the needle
valve's (2) 1/8 npt inlet. See F
IG
. 2. Screw the elbow
fitting (14b) into the 1/8 npt air supply manifold outlet.
Model 222695
Screw the air hose coupling (E) into the needle valve's
(2) 1/8 npt inlet. See F
IG
. 2. Screw the air hose swivel
stud (F) into the 1/8 npt air supply manifold outlet.
Model 224572
Attach the air line between the needle valve's (2) 1/8 npt
inlet and the 1/8 npt air supply manifold outlet. See F
IG
.
2.
F
IG
. 2: Air Line and Hose Assembly
Key:
D Air line
E Air hose coupling
F Air hose swivel stud
2 Needle valve
11 Muffler
14a Straight fitting
14b Elbow fitting
Model 222695
Model 204536
F
D
E
2
A
14b
11
2
14a