Parts Needed:Right and Left Base Feet,
Right and Left Pivot Sections (w/
Hardware Installed)
Right and Left Diagonal Stands
(w/ Hardware Installed)
4 - Wing Nuts
4 - Large Fender Washers
4 - Nylon Lock Nuts
4 - 5/16"Large Flat Washers
Pivot Sections
<
Before proceeding, be sure the
plastic rollers are in place on the
carriage bolts as directed in Steps
1 and 2.
<
Align the carriage bolts that are
already installed on the Pivot
S
e
c
t
i
o
n
s
a
n
d
the Diagonal Stands through the
holes as shown on the pictures.
The carriage bolt at the top of the
Diagonal Stand goes into the long
slot of the Pivot
Section and receives a 5/16" flat washer and nylon lock nut. The carriage bolt at the bottom of the Pivot Section
goes into the slot in the Diagonal Stand and receives a large fender washer and wing nut.
<
**Nylon side of nylon lock nuts faces out when threading onto the Bolt end.**
<
**When tightening the nylon lock nuts, leave them loose enough to spin the washer and slide the
