m908 User Manual, Rev. G
<disabled,
connector-name
>
When an input is defined it can be selected to override the current system clock source
when it is selected for monitoring. This can be useful if the input source can not be
synchronized to an external clock. If the input being defined spans across more than one
hardware connector make sure that both input connectors are at the same sample rate and
are syncronous. The clock override source can be any clock source except wordclock.
NOTE: Inputs that are defined to have a clock source override can not be included in
input summing unless the other inputs have the same clock source override.
•
demphasis
For use on stereo digital inputs where the incoming digital signal was
recorded with Red Book 15-50us pre emphasis.
Auto: The m908 looks for the emphasis bit in the AES or spdif channel status. If present
the m908 will apply the de-emphasis filter.
Off: The m908 will ignore the emphasis bit and play audio without the de-emphasis filter.
On: The m908 will ignore the emphasis bit and play audio with the de-emphasis filter.
Push the SETUP switch to save and exit Setup Mode.
6.3.6 Dim setup
Push the SETUP switch then the DIM switch to enter Dim setup. If DIM was active before
pushing SETUP it will remain active. If DIM was not active then press the DIM switch to
activate the DIM function for auditioning.
This screen contains the following a list of setup parameters that can be highlighted by turning
the VOLUME encoder knob. The available parameters are:
•
level
Clicking this option adjusts the amount of level attenuation when the Dim is active. The
range is 0dB (disabled) to -30dB
Page 81 of 135
Illustration 73: Setup Dim Screen
