Grace Digital Xlink ITC-BT, Owner'S Manual

Page: 6 / 24

6
Each XLink ITC-BT can be paired to three different cell
phones, one for each line. To pair a bluetooth cell phone to
a line perform the following steps:
1. Press and hold one of the three line buttons on the
XLink ITC-BT until it flashes rapidly (keep button
pressed for approximately 4 seconds).
2. Put your cell phone into the mode where it searches for
bluetooth devices (similar to searching for a bluetooth
car kit). This may be found in your cell phone’s menu under ‘Tools’, ‘Setup’,
‘Bluetooth’ and/or ‘ Connections’ menu. If given the choice, search for ‘Handsfree’
devices and select “Look for Devices”. Your cell phone should then scan/search for
Bluetooch devices
3. When the XLink is found, XTech Gateway will be displayed on your cell phone’s LCD.
Accept this device. In order to accept, your cell phone may ask you to do so by pressing
any number of selections including; ‘select’, ‘bond’, ‘pair’, ‘yes’, ‘ok’, etc.
4. Enter the pass code: 1 2 3 4.
5. Once the pairing is complete, the selected blue line light button on the XLink will
stop flashing quickly and remain solid.
Once paired, the XLink will remember the cell phone. Automatic connecting occurs
whenever the cell phone is within range (approx. 30ft.) of your XLink.
PaIrInG your BlueTooTh Cell Phone To The XlInk