6
the button again.
Buzzer button (#8)
To activate the buzzer, push the buzzer button.
Automatic
Freewheel switch
(#9)
Turn ignition key switch to ON then push the button to
engage the freewheel mode, push again for
disengage the freewheel mode. This function allowed
moving scooter manually.
WARNING! Do not press the automatic freewheel
button while the R8-S is moving.
Button for headlight
and rear lights
(#10)
To turn on the lights (headlight and rear lights), press
the Lights button. When the lights are on, the Light
LED is lit. To
turn off the lights, press the button
again.
After stopping
After stopping the R8-S, turn the key switch to OFF
and remove the key. The ON LED will turn off.
Note: The EMB locks automatically when the throttle
control lever is released and the R8-S has come to a
complete stop.
Safe driving
When driving on ramps, high curbs and on sharp
turns, drive very slowly and carefully, preferably with
the speed set to MIN.
When going up or down a
step, always drive so that the wheels are fully
perpendicular to the step and both of the rear wheels
meet the step at the same time.
Never try to go on an obstacle that is more than the
maximum recommended slope or curb height (see
the stabilities and the obstacle climbing specifications
given in specification Sheet) Always drive carefully
and adjust your speed to the road conditions.
Before
making sharp turns, reduce speed to minimum to
prevent side roll-over.
Climbing an
obstacle
To climb an obstacle, drive the R8-S forward toward
the obstacle until the front wheel touches the
obstacle, then, maintaining your direction, increase
