OR
Maintain water temperature: Press for 3 seconds.
When the buzzer beeps, the heater will start
boiling and the LED light will be illuminated in red.
When the water reaches boiling, the kettle will
maintain the water temperature for 2 hours with
the insulation function.
Change the temperature to 140°F: Press
once.
The LED light changes from red to green, and the kettle will
stop heating once the water temperature has reached 140°F.
OPERA
TI
NG
INSTRUCTIONS
8
9
OPERATING INSTRUCTION
S
BEFORE USING FOR THE FIRST TIME
1.
Remove all packaging, stickers or accessories from both the inside and
outside of the kettle.
2.
Adjust the length of the cord by winding it under the base. Wedge the
cord into the notch.
USE
1.
Open the lid by pressing the button
at the top of the handle.
2.
Fill the kettle with the desired amount of water:
• You can fill it through the spout, which ensures better maintenance
of the filter.
• Never fill the kettle when it is on its base.
• You must cover at lease the bottom of the kettle with water.
• Do not fill the kettle above the maximum level.
If the kettle is too full, boiling water may spill out.
• Do not use the kettle without water.
• Check that the lid is closed properly before use.
• The kettle must always be used with its own filter.
3.
Close the lid.
4.
Place the base on a flat, stable, heat-resistant surface, away
from any heat sources.
Note: Your kettle must only be used with the base that accompanies it and
with its own anti-scale filter.
5. Position the kettle on its base and plug it into the electrical outlet.
The power will turn on automatically once the kettle is placed on its base.
OPERATING INSTRUCTION
S
6. Press the button. You hear a beep and the kettle starts boiling.
Change the temperature to 158°F: Press twice.
The LED light changes from green to blue and the kettle
stops heating once the water temperature has reached 158°F.
Change the temperature to 176°F: Press three times.
The LED light changes from blue to yellow and the kettle
stops heating once the water temperature has reached 176°F.
Change the temperature to 194°F: Press four times.
The LED light changes from yellow to purple and the kettle
stops heating once the water temperature has reached 194°F.
7. Once the water reaches the boiling point, or the chosen temperature, the
kettle will switch off automatically and the interior light & indicator light
turn off.
• If you want to stop it manually, remove the kettle from its base to pour
the water.
• Make sure that the On/Off button is in the Off position after boiling and that
the kettle has switched off before removing it from its base.
• Throw away the water from the first two/three uses.
• Do not leave water in the kettle after use as this quickens the formation
of scale.
