CLEANING AND CARE
HOW TO OPERATE
1)
Plug into the AC plug into 220-240V~ socket oulet.
2)
Press the power switch (11) on the side of motor base to the “I” position and
make sure the juice container is in position.
3)
Place an orange into slicing compartment (4) with top of orange facing left side
of compartment (Figure 1). Lower lid (1) to cut orange through centre. Excess juice
will run into juice container (8).
4)
Place orange halves on cones one at a time. Remember, pressure on both
cones simultaneously will begin operation.
5)
Place another orange in the slicing compartment (4).
6)
Lower lid (1) and, using both hands on either side of the lid, apply firm pressure.
This will start the juicing operation and cut the whole orange in half. Juice will flow
into container (8) below.
7)
The appliance will not operate by pressure on one cone (3) only-both cones
must be loaded with fruit.
8)
When halves are fully juiced, discard peel and repeat steps 5
and
6 until the
juice container (8) is full (approximately 500ml).
9)
Do not fill above the max. fill line.
10)
Slide out the juice container (8) to serve the juice.
11)
The removable sleeve (9) will strain the excess pulp and any pips from the
juice. If your prefer a higher fibre drink simply remove the sleeve. The drip tray
(10) will catch any juice remaining in the juicing chamber (8).
12)
It is recommended to rinse the cones (3) and juicing chamber (8) periodically
when preparing large quantities of oranges. If the juicer stops operating during
juicing, remove the cones (3) and rinse the juicing chamber (5) to remove excess
pips which may lodge underneath the cones (3) and prevent the unit from operat-
ing.
DISASSEMBLING
1)
Switch off the appliance and disconnect from supply before changing accesso-
ries or approaching parts that move in use
2)
Slide out juice container (8) and drip tray (10)
3)
To remove slid (1), open fully and apply pressure with thumbs as shown in
(Figure 2). Lid (1) will unclip from the juicing chamber together.
4)
To prevent juice from dripping, remove the cones (3) and juicing chamber (5)
together, operating the front lever (13)
5)
Hold motor base (7) with one hand, and with the other grasp the juicing
chamber (5) at the front and pull up over the drive shafts (6). The cones (3) will lift
off with the juicing chamber (5) as shown in (Figure 3).
6)
The cone (3) may also be removed separately from the juicing chamber (5) by
simply lifting them off the drive shafts (6).
7)
The juice drip tray (10) simply slides out for cleaning.
REASSEMBLING
1)
Replace the juicing chamber (5) onto the motor base (7) by sliding the protrud-
ing lugs at the back of the juicing chamber into the slots at the back of the motor
base as shown in Figure 4.
2)
Place cones (3) onto drive shafts (6).
3)
Place the lid (1) in its original location.
4)
Slide the drip tray (10) into position along guide rails, clipping rear tab into
position.
WARRANTY DETAILS
This product is guaranteed under
a
o
ne-
year limited warranty period, applicable to
the original purchaser and not transferable to a third party user.
Repair or replacement of defective parts are at the seller's discretion. In the event
that repair isn't possible, the seller will replace the product/ part. If product repair/
replacement won’t suffice, the seller has the option of refunding the cash value of
the product or component returned.
Product defects not covered under the warranty provisions include normal wear
and damage incurred from use or accidental negligence, misuse of instruction
specifications, or repair by unauthorized parties. The manufacturing company is not
liable for any incidental or consequential damages incurred by such circumstances.
8
9
5)
The juice container (8) will then slide into position for storage.
Storage:
• Store the appliance in a cool, dry and clean place, out of the reach of children
and pets.
• Please keep the packaging for transporting the appliance or for storing your
appliance when not in use for a prolonged time period.
Product Disposal:
This product may not be disposed of along with with ordinary household waste,
as electrical and electronic waste must be disposed of separately.
Contact your retailer, distributor or the municipal authorities for further information
on product disposal.
• Always disconnect the juicer from the power supply if it is left unattended and
before assembling, disassembling or cleaning.
• All removable parts may be washed by hand in hot soapy water.
• Wash the parts which are going to be in contact with food with soapy water.
• Due to the strong natural color
of citrus peels
, the juicing chamber (5) may
discolor.
• To clean, spread the affected area with a thick paste of bicarbonate of soda and
water. Allow to stand overnight and wash in hot soapy water.
• Do not place parts in harsh cleaning agents which may adversely affect the
parts.
WIPE THE MOTOR BASE (7) WITH A DAMP CLOTH. DO NOT IMMERSE IT IN
WATER OR ANY OTHER LIQUID.
STORAGE AND DISPOSAL