27
EN
15. Unscrew the blade attachment for soup mixing container (
4
) from the soup mixing
container (
3
) anticlockwise and rinse both parts (see the “Cleaning and Storage”
chapter). Do not allow food residues to dry on.
Cleaning and Storage
CAUTION!
■
Danger of electric shock!
Remove the mains plug from the plug socket before clean-
ing the device.
■
Danger of electric shock!
Keep the motor unit, the mains cable and the mains plug
away from water or other liquids! Never touch them with wet hands when these com-
ponents are connected to the mains power.
■
The
motor unit, the blade attachments and the ice container
may
not
be cleaned
in the dishwasher!
■
Danger of injury due to sharp blades!
Take care when handling the blade attach-
ments. The blades are very sharp. Never touch with bare hands. Always hold the
blade attachment
fi
rmly by the plastic housing.
■
Surfaces could be damaged!
Do not use any caustic or abrasive cleaning agents or
scouring sponges to clean the device.
1. Make sure that the device is disconnected from the mains power!
2. If required, wipe down the motor unit (
5
) with a slightly damp cloth. Then dry it with
a soft cloth.
3. Rinse the accessories which have been used with clear, warm water and some mild
detergent. The shakers / soup mixing container (
11, 12, 3
) along with the lids and the
to-go cup with the lid (
15
) can be cleaned in the dishwasher.
4. Allow all parts to dry completely.
5. Reassemble the device.
6. Store the device in a cool, dry place which is protected from direct sunlight and is out
of the reach of children and animals.
NOTE: The plastic parts may suffer discolouration over time. However, this does not
have any negative effect on either your health or the way that the device parts work.
Troubleshooting
If the device does not work properly,
fi
rst check whether you are able to rectify the prob-
lem yourself.
Do not attempt to repair a defective electrical device yourself!
If the device will not switch on, check the following:
• Is the mains plug inserted in the plug socket correctly?
• Is the plug socket defective? Try another plug socket.
• Has the fuse of your mains connection been activated?
• Is the blade attachment (
4, 9
) screwed on correctly?
