Figure E
Route the new ColorDMD
Power Cable through the
access hole in bottom
of the backbox.
ColorDMD Ground Cable securely
installed to bare metal area.
Route to front
right-hand side
of cabinet.
'Y' Harness:
Only use this to reconnect a
pre-existing cable back into
auxiliary 5v/12v power
source connector.
Plug into
ColorDMD
PWR
ColorDMD
Power Cable
Existing 12v Power
Source Cable
System 3
Power Adapter
(BLACK Wire)
GRAY/YELLOW
'Z' Connector
CONNECT
CONNECT
POWER CONNECTOR
IN FRONT OF CABINET
NEAR COIN DOOR
WHITE
WHITE/RED/BLACK
WHITE/RED/GREEN
Locate the included ColorDMD Power Cable. One end of the cable
has a single connector (see Fig. D). Plug this connector into the
PWR header (see Fig. C) on the ColorDMD circuit board and
connect the System 3 Power Adapter to the other end (see Fig. D).
Route the other end of the new ColorDMD Power Cable down
through bottom of backbox into the cabinet and over to the front
right-hand side of the game. (see Fig. E).
9
10
Figure D
STEP
STEP
Using the 3-pin 'Z' Connector, attach the Gottlieb Adapter to the
6-pin connector located in the front of the cabinet near the coin
door (see Fig. E). Correct connector alignment will have the
BLACK wire of Gottlieb Adapter going to the WHITE wire of the
power connector in the cabinet (see Fig. D).
STEP
11
ALL RIGHTS RESERVED - US PATENT 8,773,452 B2 - COPYRIGHT 2021 - COLORDMD DISPLAYS LLC
CONNECT
