•
During operation, do not put your hands or any objects into feeder.
•
To push fruits, use only the pusher.
•
Fruits should be put into feeder during operation, you cannot fill feeder
with fruit or vegetable at a standstill.
•
Be careful not to overload the juicer, do not use too much force to push
products through the feeder.
•
Do not operate with an empty bowl.
•
Do not disassemble the juicer if it is plugged into a power outlet.
•
Do not operate the Juicer continuously more than 3 minutes with any
loading. Wait about 30 minutes before next use.
TECHNICAL DATA
•
power: 400W
•
nominal voltage: 230V ~ 50 Hz
ELEMENTS fig A
1. Bowl
2. Filter's holder
3. Filter
4. Auger
5. Lid
6. Rubber pad
7. Pulp container
8. Juice container
9. Pusher
10. Cleaning brush
11. Switch (R, Off, ON)
BEFORE FIRST USE
1. Remove all papers, cartons, foil which secure the juicer and juicer parts
2. Clean the juicer following the advice in Cleaning and Maintenance chapter.
3. It is recommended to assemble and disassemble the juicer before using.
ASSEMBLING THE JUICER AND DISASSEMBLING
Under the bowl there is a rubber pad allowing the discharge of all the juice only
from the juice outlet. Before juicing, make sure the pad is plugged in completely
to prevent any leakage.
1. Place the juice bowl (1) on top of the main body, make sure the bowl is in
place by inserting the pins on the main body into the 3 slots on the bowl bottom.
2. Put the filter (3) into the filter's holder (2).
3. Put the filter's holder (2) with filter(3) into the juice bowl (1). Besure to align
the arrow on the filter (3) with the arrow on the bowl (1). Make sure that the
teeth along the lower edge of the filter's holder (2) fit properly into the cogwheel
inside the bowl.
4. Put the auger (4) into the filter and rotate until it falls into place.
9
