6
GMC-I Messtechnik GmbH
1
Applications
The PRO
Fi
TEST
®
C measuring and test instrument allows for rapid and
efficient testing of protective measures in accordance with DIN VDE 0100,
ÖVE-EN 1 (Austria) and NIV/NN SEV 1000:2010 (Switzerland), as well as
other country-specific regulations. The microprocessor controlled device
complies with regulations set forth in IEC 61557/EN 61557/VDE 0413.
Part 1: General requirements
Part 3: Loop resistance measuring instruments
Part 6: RCDs in TT and TN systems
Part 7: Phase sequence indicators
The test instrument is especially suited for:
•
Set-up
•
Initial start-up
•
Periodic testing
•
Troubleshooting in electrical systems
All of the values required for approval reports (e.g. for ZVEH) can be
measured with a test set consisting of the PRO
Fi
TEST
®
C and the
METRISO
C
. Measurement values can be transmitted to a PC, and
printed out or archived with the infrared data interface which has been
integrated into the PRO
Fi
TEST
®
C. This is very important, especially
where product liability is concerned. The applications range of the
PRO
Fi
TEST
®
C includes all alternating and 3-phase current systems with
230 V line voltage and 16
2
/
3
Hz, 50 Hz and 60 Hz line frequencies.
The following can be measured and tested with the PRO
Fi
TEST
®
C:
•
Voltage
•
Frequency
•
Phase sequence
•
Loop impedance
•
RCDs
•
Earthing resistance
Seal of Approval
2
Safety Features and Precautions
The PRO
Fi
TEST
®
C electronic measuring and test instrument has been
manufactured and tested in accordance with safety regulations IEC/
EN 61010-1/VDE 0411-1 and EN 61557.
If used for its intended purpose, the safety of the operator and the
instrument are assured.
Read the operating instructions carefully and thoroughly before using your
instrument, and observe all instructions included therein. Make sure that the oper-
ating instructions are available to all users of the instrument.
Tests may only be performed under the supervision of a qualified electrician. The
user must be instructed by a qualified electrician concerning performance and
evaluation of the test.
Note
Manufacturers and importers of electrical medical devices must provide
documentation for the performance of maintenance by trained personnel.
The measuring and test instrument may not be used:
•
If the battery compartment cover has been removed
•
If external damage is apparent
•
With damaged connector cables and measuring adapters
•
If it no longer functions flawlessly
•
After excessive stress due to transport
•
After lengthy periods of storage under unfavorable conditions
(e.g. humidity, dust, extreme temperatures)
Meanings of Symbols on the Instrument
Warning concerning a point of danger
(Attention: observe documentation!)
Protection class II device
CAT III
Measuring category III device
9 V DC charging socket
for NA102 charging adapter (article no. Z501N)
!
–
