12
Default: PSS;1;3;2
21.Command LED
This command is to set LED behavior.
1234,LED;300;10
Tracker
Remark
User SMS
G2P V1.00
LED:300;10
BAT 60%
#6
LED;<Power saving>;<Cycle interval>
<Power saving>:
Value can be 0, and integer between 60 to 65535, unit is second.
0 = Disable LED power saving mode, LED behavior always stick with
chapter 6.
60 to 65535 = Any value between will enable LED power saving mode.
If battery is under “Normal” status, after power on G2P LED will only
work for such duration and
stop working
(power saving purpose), until
battery is under “Charging/Charged/Low voltage” status LED will work
again as chapter 6 shown.
<Cycle interval>:
This value defines interval between each LED cycle, default is 10
seconds.
E.g.:
Command BMC set as BMC;60, command LED set as LED;300;10, and
current battery is 70% full, operating on battery only.
So since power ON, at the first 5 minutes LED will work as chapter 6 and
then stop working, afterwards battery drops under 60% (or connect
with charger) LED will start working as Chapter 6 shown again.
Note: If any LED status changes then the <cycle interval> will be forced as 5 seconds for one time.
22.Command MGR
This command is to check current accumulation mileage of tracker, unit is meter.
1234,MGR
Tracker
User SMS
G2P V1.00
MGR:100000
BAT 60%
#6
23.Command CID
This command is to check CCID of tracker SIM card.
1234,CID
Tracker
User SMS
G2P V1.00
CID:89860090191149028638
BAT=3.90V
#7
